Introduction: Play Music With Drivemall
If we do not have the drivermall we can use the arduino, but below the link for the development of the Drivemall.
The advantage of prefering the Drivemall over the classic Arduino board is that of reducing the complexity of the connections leading to a more tidy setup (in some cases). However, this is optional: all the results are still valid with the arduino board, a breadboard and enough dupont jumpers for connections.
1 transistor 2n2222
1 1K Ohm resistor
1 10K Ohm resistor
The project aims to promote an informal form of education as a means to foster social inclusion of young people, informal education as can be found within makerspaces.
This tutorial reflects the views only of the authors, and the European Commission cannot be held responsible for any use which may be made of the information contained therein
Step 1: Connections
Connect the components according to the schematics.
Step 2: Firmware and Testing
Load the firmware via the Arduino IDE. You can modify the melody by suitably modifying the vectors "melody" and "noteDurations", for the notes and the relative durations.