Origami Cat

11,345

30

5

Introduction: Origami Cat

This model by Makoto Yamaguchi. is a little more advanced - so you might to take a closer look and try more than once.

you can either use this Video tutorial below or use the following images in the next steps.

Supplies

As with most Origami: you just need just one sqaure sheet of paper. I used 15cm/8inch paper.

Step 1: Fold Diagonally

Step 2: Fold Into a Kite Shape

Step 3: Fold Tip Up

Step 4: Fold in Corners

Step 5: Fold Up Corner

Step 6: Fold in Diagonals of Left Part

Step 7: Waterbomb Base

collaps from both sides.

Step 8: Fold in Top Corners to Center

Step 9: Squash From the Side

Step 10: Fold the Tip Up

Step 11: Rabbit Ear "sholders" on Both Side

Step 12: Pull Out Additonal Paper Under "shoulders" on Both Sides

Step 13: Refold to Cite Shape

Step 14: Fold in Half

Step 15: Wrap Shoulders Back and Tilt Head Down

Step 16: Inside Reverse Fold Tail

Step 17: Crimp to Make Tail Slim

Step 18: Last Tail: Fold Up Tail

1 Person Made This Project!

Recommendations

  • Lamps Challenge

    Lamps Challenge
  • CNC and 3D Printing Contest

    CNC and 3D Printing Contest
  • Rice & Grains Challenge

    Rice & Grains Challenge

5 Comments

0
Cute_Frog
Cute_Frog

1 year ago

This project was tricky, but it was fun! I liked the video more than the pictures since it is more detailed, but the pictures are good too.

0
WestWindsDemon
WestWindsDemon

Tip 1 year ago

There are a few folds in there that can be tricky, especially for origami beginners (like myself). I strongly encourage you to watch the embedded video while making it.

0
X_scorpion_X
X_scorpion_X

2 years ago

cool! I like it! could you male a paper jet?

0
X_scorpion_X
X_scorpion_X

Reply 2 years ago

*make