How to Run an Auto Steer in a 2019 John Deer

Introduction: How to Run an Auto Steer in a 2019 John Deer

The simple way to run John Deer auto steer

Step 1: First Step Is to Start the Tractor Up

The first step to do is

start tractor and let it warm up for fifteen to twenty minutes. After that press the ok button on the top corner of the screen, then go to auto track and use the arrows on the top right corner on the screen until the operator get the guidance screen on the left top corner.

Step 2: Step 2 Should Go to the A&B Line

At the bottom left corner there is a tab that says guidance the operator

should press that button twice. The next step is to setup the tracing which the operator should scroll down until they see the new tracking button click that, then press straight tacking tab on the left side you will want to press the A + B Method. Begin at the start of the field and progress your way through the field with using auto steer.

Step 3: Step 3 Start a New Tracking

At turns the operator have to manually use the steering wheel to get to

the next rows you would like field cultivate. When approaching the end of the field you want to switch to the B method in the top left corner and it will create of mapping of the field for the operator to what all has been covered.

Step 4: Step 4 the End Page

The next rows you would like field cultivate. When approaching the end of the field you want to switch to the B method in the top left corner and it will create of mapping of the field for the operator to what all has been covered.

Be the First to Share

    Recommendations

    • Lamps Challenge

      Lamps Challenge
    • Rice & Grains Challenge

      Rice & Grains Challenge
    • CNC and 3D Printing Contest

      CNC and 3D Printing Contest

    Comments