Introduction: Electric Boat
Small plastic box
2x dc motors
2x 9V batteries
Hot glue gun
Step 1: Making the Holes for the Motors and the Switch
Make holes in the plastic boat with a soldering iron wich are big enough for the shaft of the motor to pass through ,but not big enough so that water comes in. Do this twice .
Step 2: Making the Hole for the Switch
Using a soldering iron again cut out a hole for the switch preferebally on the top half of a boat. Make sure the area is watertight , by using some hot glue.
Step 3: Wiring
Take two 9V batteries and connect them in series, this can be done by connecting the negative terminal form one to a positive one from another.
Step 4: Wiring the Motors.
Do this with reference to the image. Then also attach the propellers when done.
Participated in the
Battery Powered Contest