Introduction: DIY | Joystick Controlled Remote Car Using Arduino
All of us Likes to play with a Remote controlled car.
Here , we are going to make a car which can be controlled using a Joystick or Buttons
Step 1: Watch the Video
Please watch the video before building your own Remote car.
Step 2: Gather Required Parts
Parts List: (Amazon.in)
4wd Car kit : https://amzn.to/2R5F7rP
Arduino UNO : https://amzn.to/2R5F7rP
Arduino Nano : https://amzn.to/2R5F7rP
L298 Motor Driver : https://amzn.to/2R5F7rP
nRf24L01 Modules : https://amzn.to/2R5F7rP
Joystick : https://amzn.to/2R5F7rP
18650 Li-ion battery : https://amzn.to/2R5F7rP (If possible buy this from local shop)
18650 Li-ion battery charger : https://amzn.to/3uB7OLB
Battery Holders : https://amzn.to/3uB7OLB
Wires : https://amzn.to/3uB7OLB
General purpose PCB : https://amzn.to/3uB7OLB
20 mm berg strips : I bought this from local electronics shop
Scotch Tape : https://amzn.to/3uB7OLB
Switches : Local Shop
Soldering Iron : https://amzn.to/3o4emjm
Iron I used : https://amzn.to/3o4emjm
Step 3: Build Transmitter and Receiver
With help of provide schematics build the Transmitter and Receiver.
Step 4: Upload the Code and You Are Ready to Go
Please be careful with Lithium ion batteries.